|
11) PRESS TOOLS (TOP BOTTOM)
These presses are specially designed for cutting,
blanking, piercing and embossing on flat or circle
sheets.
The press is of heavy construction in conjunction
with rigid design to give it great stability even
when presses are on Mass production.
12) PRESS TOOLS (FILLER HOLES AND BUNKS)
These presses are specially designed for filler
holes, bunks fixing after formation of top.
The press is of heavy construction in conjunction
with rigid design to give it great stability even
when presses are on Mass production.
13) PRE CURLING MACHINE (TOP BOTTOM)
Semi Automatic type, where the component is placed
on the table and the chuck, will come out with
carry component and start rotating. Top spring
loaded support will always be pressing the component
so that the component formally sticks with chucks,
after which one curling roller will come and automatically
curl the component.
14) SEMI AUTOMATIC DRUM SEAMING MACHINE
This machine will seam drums at approximately
three seems per minute. A double cone clutch and
break is fitted to enable accurate registration
of the filling and vent holes in drum body, and
top to be maintained, but the machine may be set
so that the chuck runs continuously thereby increasing
the output.
  
15) HEAVY DUTY HORIZONTAL TRIPLE AND SPIRAL
DOUBLE SEAMER
Semi-Automatic heavy duty horizontal mounted
on a fabricated steel bed. Main power drive operated
through Air clutch and break assembly. Also reduction
chain to the Main drive shaft. Chuck spindles
and Cam shaft are all chain and gear driven. The
chuck spindles are extremely heavy and mounted
on large taper roller bearing. One Headstock is
operated by double acting air cylinder for clamping
and declamping.Both side seaming operation at
one time.
16) DRYING OVEN
Stationery oven having insulated walls roof with
both sides opening for charges and discharges
with internal exhaust fans revolving arrangement
with rails for trolleys with control panel thermostats
and temperature gauges with accessories complete.
 
17) DOUBLE ENDED CORRUGATOR
Main columns are mounted on A four chrome plated
pipe. Main power drive operates through air clutch;
break assembly and reduction gear to main drive
shaft. Roll shaft are chain and gear type. The
roll shaft are extremely heavy on large pillow
block heavily .Two head stock are operated by
double acting air cylinder for clamping and declamping.
|
